- Fuel Question
- Gear oil
- 92 trans in 90 car
- Wideband guages?
- more tuning questions
- custom axles
- Timing belt and water pump labor
- 90 Oil cooler
- Car wont start..please help..
- Question about a 95 talon ESi
- s-afc 2
- Porting 2g head...
- Clutch Pedal Noise?
- Water pump question...
- OBd2 cable question.
- Whats the best Coilover/ shocks combo for a 2g awd?
- which springs are better for drag racing launching etc.
- Car won't start
- SS brake line question
- Battery Light, ABS, SRS Then car shuts off
- using boost to tune with AFC
- Part 2. Could anybody help me change stripped wheel studs?
- Barometric sensore error
- A few general maint quesitons if you guys dont mind...
- afpr install
- Idle surge on cold mornings
- HEAT problems
- Broadway Performance
- Turbo suggestions and engine pics.
- 1G cas question..
- AEM wide band
- altenator
- Oil Filter Relocation Kit
- My waterpump died and I think my head is fucked..
- Welding a t3 flange to stock manifold..
- How far can a piggyback system take you?
- egt gauge power
- Screwed up my first tranny install: need help
- IS my Turbo dying?
- AEM question
- plastic circular plug for head? what is it?
- EProm Ecu
- Exhaust flanges?
- Need to make a washer fluid tank
- non DSM related question...don't be angry!
- I give up ... N/a 4g63 problems help!!!!!!!
- Engine rebuilt kit
- Bushur racing coil on plug
- G4CS?????
- Engine codes
- 4 bolt question
- 1997 Hyundai Accent 4g63 Swap???????
- running rich or something else?
- Starter or alternator ?
- 2g piston question
- 2g: Car won't go into gear
- Are 1G and 2G knock sensors compatible?
- Car won't start: Cam. Pos.Sens. 180* out of phase?
- Link to the "old" tech archives
- Discuss: DSMLink w/VPC?
- 95gst died tonite
- Power Steering?
- valves ?????
- RPM surge
- Summer tire review: Car and Driver tire tests
- Carbon Fiber hood???
- Flickering Dash Warning Lights
- BB turbo question
- 97 GST New 2 Me
- Ebay Air Filter vs. Aftermarket filter
- Battery Light
- a trio of dummy lights for the dummy
- Zeroshift Transmission
- Ecu Identification
- Hitting fuel cut @ 5500rpm...
- Help installing/tuning VPC
- Ebay seller
- No spark; car won't start
- CAN'T HOLD BOOST! ANY IDEAS?
- What do you guys think of this 6bolt longblock
- 2.1 vs 2.4
- head stud thread size..
- READ THIS FIRST!
- retorque crank sprocket?
- Which of these kits do you think probably fits?
- valve cover
- Motor weight
- 14b and stock injectors..
- HKS cam ??????
- 7 bolt motor rebuild advice
- Should I rebuild it?
- helicoil help
- Head Rebuild
- Help with strut install!
- Question on Mach V lifters.
- Stupid question
- Clutch issues
- Ebay HID kits
- Draining the gas tank
- delete this
- T67 Spool time on 2.4??
- rev then dies?
- CAS Question
- rust...
- reverse light
- altenator
- "Crank Space Washer"???
- 420a to 4g63/64 swap?
- tranny or xcase problems?(1gAWD)
- should i build my motor?
- Spearco 2-216
- clutch ?'s 6 puck or street disk?
- can i switch pocket logger?
- ES bushings install
- Evo steering wheel in my 2g gst?
- seat harness mounting
- Crank Bearings??
- Coilover setup opinions
- 2g Alternator on g4cs?
- 2g ebrake
- is there a difference between....
- Fuel pump relay/fuse??
- vibration
- how do you check for vac leaks? and operating ISC?
- Motor build tips
- clearance issues
- Eagle Is Making 4G63 Cranks?
- Another blown up ACT
- changing a clutch in a 2002 wrx
- xcase or driveshaft.......who's at fault?
- smell
- #1 inj not spraying (fix)
- ? on walbro
- Turbo exhaust on 420a motor ?
- turbo comparrison
- clutch issues
- clutch pic
- my oil light is coming on
- water pipe
- VPC or not to VPC
- Anyone try this before?
- recieved my new turbo
- tune and boost ?
- Dim Dash light Problem. Need help quick!
- 2gnt shift tower = 2gt shift tower?
- dsm weight loss program...
- Civic GSR Smoking
- what a pain
- valve seals q'
- 2g tranny mount
- Camber Kits
- Blow by???
- VPC question
- dsmlink
- Piston\Rod disassembly
- Throttle Body Rebuild?
- power steering question
- boost controller
- Springs
- AFPR Installation
- Strong bolts?...
- Thought this may help.....
- 1 or 2 resonators on a 3" exhaust?
- 6bolt swap
- any suggestions on a good glue
- MAF sensor voltage?
- Supra SMIC
- our knock sensor
- Boost Creep?
- Gas Light
- POS?
- what turbo for my 2....
- 4G63 Megasquirt interest
- Valve Cover Bolts
- Help
- Shift Knob
- Bad gashes and paint flakes
- setting base timing..
- Major white smoke
- any special tricks to getting axle out?
- Stud removal
- shimming a new pivot ball?
- cutting and looping PS lines?
- spark plugs???
- Car Height has been altered
- i wonderfull tooner talking about injectors
- low vac in cold days
- Question For Those With an Atmospheric Dumped Internal WG
- Squeeking Halfway through friction point
- Which clutch should i get?
- so my car makes this weird sound now...
- 2.3 build
- Help me choose injectors
- Karman readings
- P0300...Random Misfire....stock 7bolt
- Antifreeze leak
- taking the head off the block..
- EGT Install
- Boost but Not the Right amount.
- Bumper reinforcement???
- Coolant recirculation question
- Specific 4g63t Engine Specifications
- oil IN my ISC.. WTF
- Blown Engine?
- inspection time....
- Starter,Battery or What???
- Lifter tick
- Cold start and hot start problems
- Batt will drain if not disconnect after driven
- Help picking injectors.
- Recall on "SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOIN
- the great brake debate
- What a Boost creep!!!
- are my ISC driver's on the ECU shot?
- Brake Caliper Fitting
- Throttle Body Question
- EGT gauge test
- question for you supra guys
- Wheels question
- Erratic idle
- 4G63 ---> 4G63-T
- exedy clutch kit thick or thin?
- Tricks for taking off turbo
- Having a problem wit my car need help
- Anybody with access to a plasma cutter?
- any one here good with AEM EMS,having trouble starting it
- 91 Throttle body
- Looking for tires!
- quick question about AWD and different rims
- JDM CYCLONE MOTOR
- How to install 2g mas to 1gen?????
- What size bit for 1/8 NPT tap?
- 2g Clutch problems any thoughts ?
- Thoughts on a rebuilt motor
- I'm new to mitsu and hoping to get some questions answered.
- Who cuts brake Rotors on sunday (tommorow)
- cross threaded sparkplugs
- bad afr problems
- engine just broke
- greddy type s
- Turbo outlet pipe
- Custom fab machine shops?
- need help with cooling problem
- Engine bearings
- how to chose injector size
- tie rod ends/rack questions
- Market survey
- Turbo intake diameter size
- how accurate is dsm link?
- Can I disconnect the driveshaft to two dolly a GSX?